大家在查： influencing 分配 lunged ads itself girlfriend 芭东弗莱尔拉斯穆森开放

阀座

na.seat; valve seat; clack seat
网络Seat; Seat Ring; valve base

阀座

英-汉网络释义

阀座

Seat

电动阀接线图 ... 材质 Material 阀座 Seat 橡胶 Ruber ...

valve seat

消防专业英语词汇表 ... valve pressure drop 阀压降 valve seat 阀座 Valve setting 阀调整 ...

Seat Ring

yoke bush是什么东西阀门上的词汇_百度知道 ... 阀形活塞泵 valve type piston pump 阀座 Seat ring 阀座 valve carrier ...

valve base

valve 阀门专业词汇A-Z ... valve base pin 电子管管脚 valve base 阀座 valve block 给油阀组; 阀组箱 ...

valve cup

valve 阀门专业词汇A-Z ... valve crash speed 气门落座速度 valve cup 气门防油罩; 阀座 valve current 电子管电流 ...

clack seat

be seated的翻译中文意思-在线英汉词典 ... check valve seat 止回阀座 clack seat 阀座 classical seat (花式骑术)古典骑坐姿势 ...

Body Seat

减压阀-FIG.100S 不锈钢水用减压阀... ... 心轴 Stem 阀座 Body Seat 阀门垫片 Disc Seal ...

valve support

航海及海运专业术语V(1) ... valve stroke 阀行程 valve support 阀座 valve tappet adjustment 阀挺杆调整 ...

例句：

The nozzle equipment is at the bottom of the valve seat ; the valve spool has a balancing hole; the valve spool bush has an orifice .

喷嘴装置在阀座下端，阀芯设置有平衡孔，阀芯套开设有节流孔。

Take one body half and, starting at the bottom of the valve, work the end flap of the elastomeric seat into the opening of the body .

拿起一半阀体，从阀门底部开始，将弹性材料阀座的边缘放入阀体的开口处。

Oil port is set at the front of valve base and is corresponding to the oil channel of sealing pair of variable flow .

阀座的前端设有油口，与变流量密封副的油道相对应；

The seat back in a few years ago gave you issue the ultimatum , and you do not dare looked down on the seat !

阀座早在几年前给你问题最后通牒，和你不敢往下看在座位上！

WILLIAMSONs metal to metal sealed trunnion ball valve is in general of the front ball sealing structure .

威廉姆森金属硬密封固定球阀一般采用球前阀座密封结构。

The body side seat has a rib molded into the seat ring which locks into a groove in the valve body .

阀体侧面阀座有模铸肋条，镶嵌在阀座环内，并将阀座锁定在阀体凹槽内。

If the valve seat diameter is not known, the port diameter can be assumed to be the seat diameter for estimating purposes.

阀门阀座直径。如果不知道阀门阀座的直径，则可以将端口直径作为阀座直径进行估算。

This design minimizes galling tendency with non-hardened stainless steel seats and is less likely to stick in the body seat .

这种结构将未硬化不锈钢阀座的磨损可能性降到最小程度，也降低了卡在阀体阀座上的可能性。

The specially-designed compensatory movable valve seat construction made from metal is of great reliability in its sealing performance.

采用特别设计的补偿性可动金属阀座结构，蝶阀密封可靠。

Install the valve with the higher pressure against the side opposite the seat when the valve is closed . Flow may be in either direction.

安装阀门时，现将阀门关闭，然后将较高压力的一端对着阀座的反面。流体可以从两面中的任何一面流过。

The perimeter seat is locked into the body dove tail groove and is further retained by a metal wire insert .

周长阀座锁定在阀体内的下部尾槽上，并且采用金属线嵌入件进行进一步的加固。

Seat end of valve must be mated to a standard flat faced metal flange . Rubber flanges not acceptable.

阀门的阀座端口必须与平面金属法兰配合。橡胶法兰是不可接受的。

Stellite faced Seat Rings are welded into the body . This provides a positive no-leak seal of the ring in the valve body .

阀座环采用钨铬钴硬合金覆面，并焊在阀体上。这就在阀体内实现了无泄漏密封。

In general, WILLIAMSONs trunnion ball valve features the front ball sealing design structure .

威廉姆森固定球阀一般采用球前阀座密封结构。

No matter how the valve is installed, the back of the upstream seat protects the face of the downstream seat .

无论阀门如何安装，上游阀座的后背都能够保护下游阀座的表面。

The assembly shall consist of a pressure differential relief valve located in a zone between two positive seating check valves .

这种总成在两个正向阀座止回阀之间的区域内应该配置压差安全阀。

All valves to be fitted with PTFE inserts in the seats and the seats are to be screwed in the body .

所有阀门的阀座需嵌入 PTFE 且阀座需旋入阀体内。

Can swipe the spheroid clean on the sharp valve seat edge at the time of each operation .

每次操作锋利的阀座边缘都可以把球体刮擦干净。

Its sealing surfaces is welded with cobalt , chromium , tungsten alloy and seat and shaft are made of stainless steel .

阀门的密封面采用钴、铬、钨合金堆焊，阀座、阀杆全用不锈钢制作。

The utility model relates to the exhaust valve of a pressure cooker, which is composed of a valve seat and a valve core .

本实用新型涉及一种高压锅的排气阀，由阀座、阀芯构成。

The pivots are located just above the center of the disc , and offset from the plane of the body seat .

枢轴就位于阀瓣中心上，偏离阀体阀座平面。

Metal-to-metal seating means not best choice for frequent operation . Bubble-tight seating should not be expected with metal-to-metal design .

金属对金属阀座意味着不适用于频繁操作。金属对金属结构也不适用于无气泡阀座。

阀座

阀座